6/27/2023 0 Comments Cetus3d printer passwordfind bed height again using G1 Zxx moves (5.Barcodes, Partkeepr and parts providers(TME) Password management in the terminal done. paper is dragging but a little looser, so almost OK Teensy MIDI controller Cetus3D printer mods (free cetus ).approach in steps to avoid a bed crash, ended with G1 Z0.set OctoKlipper 'Coordinate offset' to Z=5.3 (so Z=0 is now the bed height). ![]() use Octoprint controls to do the paper height test.The attached log file was taken after the following test: Any ideas or things to test would be welcomed. When I was using it with Smoothieware I set the bed height once and used it for a couple of months with no need to ever change it by even 0.1mm. I can't see why the Z won't zero reliably. However I only did that because the standard setup, with a friction brake to avoid the arm dropping when the steppers were de-energised, was showing the same issue. Add a description, image, and links to the cetus3d topic page so that developers can more easily learn about it. python status esp8266 progress reverse-engineering discovery arduino-library wireshark 3d-printer cetus3d Updated Jul 31, 2020. My Z axis is counterbalanced using a spring rewinder (like a tape measure coil spring) so is effectively much lighter than the standard setup, putting less load on the stepper. Note Devices that are affected when using smart card (PIV) authentication should work as expected when using username and. You can use Micro USB or a TF Card to upload models you wish to print, or you can control and send print jobs to Cetus2 remotely through its Stable WI-FI connection. Library for getting the status of the Cetus3D printer. X and Y I have driven up to 250mm/s and they seem to work fine and repeatably. Cetus2 3D Printer Automatic Build Platform Wand Controller Support. I'm driving the Z axis at approximately the same slow speed (8mm/s) as the original Cetus software used. But when it's printing the layer heights seem to be OK. The remaining big issue is that I can't get Z homing to work, the zero position varies every time I do large Z moves (to the Zmax microswitch endstop or not) by up to 20mm. I'm nearly there, it's printing reasonably well and quickly. ![]() I'm setting up Klipper to work with my Cetus3D fitted with a Tinyfab (smoothie) controller.
0 Comments
Leave a Reply. |