6/24/2023 0 Comments Dockstar hungary![]() In its earliest and simplest iterations, the Wedge was a manually activated transom-mounted hydrofoil that lowered and locked into place. Malibu SurfGate Wedge and Surfgate Malibu introduced its Wedge decades ago. What we’ve tried to do with this roundup is highlight some of the more unique technological advances in the industry by brand and by innovation, in the hope of helping you hone in on the tow boat that fits your needs. Other bits are unique to a builder here and there. Some of this technology is found on all tow boats. No, what makes boat builders’ use of technology is that those fingertip touch screens control electromechanical devices that greatly alter the character and shape of the wakes the boat leaves behind. Of course, the adoption adaptation of Silicon Valley technology alone wouldn’t be very impressive because we’re all so inundated with it every day. Using the same technology we find on our favorite smartphones and tablets, tow boat builders are putting far greater control right at our fingertips. Currently, the recreational boating market has been adopting new technologies, but it seems watersports boat market has been leading the charge. The arms race was on, and we talked about it in detail in this story from 2013. Correct Craft introduced the tower, which gave riders an upward pull rather than a lateral tug of a tow pylon, and for all intents and purposes, the industry was given a new life that has been building momentum ever since. Then, along came wakeboarding, which took an industry that sought to make as flat a wake as possible, and turned it into one looking to make waves. Water skiing had entered a period of stasis. Water-ski shows, if you remember those, seemed to have lost their magic. Ski boat sales had decreased because there was nothing really new in watersports. a/arch/arm/mach-kirkwood/sheevaplug-setup.About 20 years ago, the watersports industry was looking a bit stodgy. ![]() Change to build_dir/linux-kirkwood/linux-2.6.30.10 and apply the following patch: (This step isn't required, but I recommend it for easier recovery from bad flash writes below.) Use "make kernel_menuconfig" to add built-in SCSI disk, USB EHCI, USB storage, and ext2 filesystem support.ģ. Also select built-in luci and ntpclient packages. Add squashfs in the target images section. Use "make menuconfig" to configure the build system for a kirkwood target. You need to build your own OpenWrt kernel and root filesystem image, because the Marvell Kirkwood target currently supports only the Sheevaplug, which has a different NAND flash layout. ![]() See this page for the serial pinout (and how to open the case) and this page for a picture of where to find the connector.Ģ. Open the case and install a serial cable. No one has tried to restore the factory firmware yet, so we don't know whether that's possible. ![]() WARNING: this approach requires you to open the case and install a serial cable, and completely replaces the factory-installed software with OpenWrt. Update: I've consolidated this HOWTO and the following one into a single guide to installing OpenWrt on the Dockstar. This post describes how to install an OpenWrt kernel and rootfs on the internal NAND flash of the Seagate Dockstar so that it will boot into OpenWrt at power-on, with no USB storage device required.
0 Comments
Leave a Reply. |